Dulux - Paint - Metalshield Quick Dry - Enamel - Gold Yellow - 4L

Features

High gloss finish

Rapid dry & recoat

Extensive colour range using colorfast tint system

Applications

Metalshield QD Enamel Topcoat is ideal as a coating for steel in mild and commercial environments

The preferred coating where a hard wearing, fast dry, easy repair and recoat finish is required

Used to paint machinery and equipment such as:

Cranes

Trailers

Pumps

Compressors and as a general purpose fast dry enamel

Application Method: Conventional or airless spray

Weatherability: On exterior exposure some chalking may also occur

This will not detract from the protective properties of the coating

Heat Resistance: Up to 80°C dry heat

Water Resistance: Resists rain and condensation

Not recommended for permanently damp or immersed exposure

Abrasion Resistance: Good abrasion resistance when fully cured

Solvent Resistance: Resists mineral turpentine

Limited resistance to strong solvents

Acid Resistance: Resists mineral turpentine

Limited resistance to strong solvents

Alkaline Resistance: Not recommended where fumes, splash or spillage may occur

Salt Resistance: Poor resistance to most salt solutions

Drying Characteristics:

Touch Dry20 minutes

Full Cure7 Days

Re-Coat Time:

24 Hours

Overcoating can occur up to 4 hours after the initial application or after 24 hours

Failing to observe these limits may result in "frying"

If in doubt test a small inconspicuous area first

Allow longer times under cold conditions

Specifications

STEEL Mild Environments Hand &/or Power tool clean AS1627.2: St 3 Abrasive blast AS1627.4 Class 1

Typical System: 1 x Metalshield High Build ZP @ 50 microns + 1 x Metalshield QD Enamel Topcoat @ 40 microns

Minimum sell quantity:

Order Quantity Multiple: